Ironworker Machine Videos - Piranha Metal Fabrication Equipment by MegaFab

Voltage Change on Single Operator Piranha Ironworkers

Piranha — Thu, 02 Aug 2018 00:01:28 +0000

Voltage Change on Single Operator Piranha Ironworkers

To change the voltage from 230 volts to 480 volts or 480 volts to 230 volts on single operator P-model Piranha Ironworkers, follow these 4 basic steps.

The post Voltage Change on Single Operator Piranha Ironworkers first appeared on Piranha Metal Fabrication Equipment by MegaFab.

Tips: Round Bar Shear on Piranha Ironworker

Piranha — Wed, 01 Aug 2018 23:53:46 +0000

All of our Piranha Ironworkers come standard with a round bar shearing section, with the exception of the P50, which can shear round bar with an optional attachment. If you want to cut smaller sizes of round bar, different sizes of blade can be purchased from our parts and service department for the highest quality cut.

The post Tips: Round Bar Shear on Piranha Ironworker first appeared on Piranha Metal Fabrication Equipment by MegaFab.

Serial Number Location for Piranha P-Model Ironworkers

Piranha — Wed, 01 Aug 2018 23:49:06 +0000

The serial number for all p-model (P-40, P-50, P-70, P-90, P-120) is located below the shear table, riveted to the lower beam. The serial number follows the model number.

The post Serial Number Location for Piranha P-Model Ironworkers first appeared on Piranha Metal Fabrication Equipment by MegaFab.

How to Properly Adjust the Punch/Stripper Attachment: Piranha P-model Ironworkers

Piranha — Wed, 01 Aug 2018 23:44:13 +0000

Note: Machine may have either adjustment caps if a newer machine or socket-head bolts if an older model.
1. Run the machine to full up and shut it off.
2. Remove the die from the die block to avoid damage to tooling.
3. The punch should extend just past the bottom of the lower stripper foot. Hold a flat surface to the stripper foot to determine the position of the punch.
4. On newer machines, loosen the set screws on the adjustment caps. On older machines, remove the chrome caps from the adjustment bolts.
5. Turn the machine on and run it down to where the stripper foot just touches the die block. This relieves the pressure on the caps or bolts and will allow them to turn freely.
6. Adjust the caps or bolts so that half of the centering tip of the punch protrudes below the die block. Run the machine up if necessary.
7. After adjusting the punch, run the machine down again, making sure that the stripper foot touches both sides of the die block at exactly the same time. Adjust if necessary.
8. Lock the set screws on newer machines or replace the chrome caps on older machines.

The post How to Properly Adjust the Punch/Stripper Attachment: Piranha P-model Ironworkers first appeared on Piranha Metal Fabrication Equipment by MegaFab.

P50 Piranha Ironworker Safety and Operational Guide

Piranha — Wed, 01 Aug 2018 23:38:27 +0000

P50 Piranha Ironworker Safety and Operational Guide

Disclaimer

This safety and operational setup guide is provided by Megafab, maker of the Piranha line of hydraulic Ironworkers. This guide is designed to assist the end user in safe set up, operation, and maintenance of Piranhas ironworkers. However, it should not be used as a substitute for thorough operator training.

The post P50 Piranha Ironworker Safety and Operational Guide first appeared on Piranha Metal Fabrication Equipment by MegaFab.